Home>PRODUCTS>HLD-2000



☆ Extremely high-speed labeler - It can cut over 130 pcs. / min. (40mm pitch label)
☆ The motor can stand 24 hours.
☆ Very compact design fits cell-system.
☆ Utility holder can firmly hold the label roll easily.
☆ Can cut label, Die-Cut parts and security tape.
☆ Be careful to handle ESD type.
☆ It is easy to adjust the photo sensor for different types of label.
☆ Scrap winder can remove scrap automatically.

 

2.8MB 1.4MB 1.1MB 0.6MB
Specification
Length of Label 15mm to 100mm
Width of Backing Paper 10mm to 75mm
Feeding Speed 130pcs./min. (Label pitch=40mm)

Diameter of Outside Roll

 180mm
Dimension 192mm(W) x 170mm(H) x 253mm(D)
Weight 4.2 kgs.
Power Requirement 220-240V, 120V, 100V
If scraps become more, the standstill point will be changed by special quality motor.



Precision Label Dispenser

This is the first ESD label dispenser in the world.

The static voltage reading is less than 5 volts.

The error of standstill point is only 0.14 mm.

Can cut 4 x 4 mm extremely small ESD label.

It is easy to adjust the photo sensor for different types of label.

Can cut not only label, also die-cut parts and security tape.

Very compact design fits cell-system.

Also can be used in clean room.

Scrap winder can remove scrap automatically.

Specifications
Label Length 4 mm-100 mm
Label Width 4 mm-75 mm
Feeding Speed 8.3 mm / sec.(min.) 14.0 mm / sec. (max.)
Error of Standstill Point 0.14 mm (min.) 0.31 mm (max.)
Dimension 192(W) x 170 mm(H) x 253 mm (D)
Weight 3.1 kgs.


The specifications are subject to change without prior notice.

Home>PRODUCTS>HLD-2000